This function selects the default language for all customer screen transactions and management function screens.

Available options are:

• English

• French

• German

• Spanish

NOTE: This function is only active if the option to allow customer selection of a language has been disabled through the optional screens and optional buttons functions.

This function changes the default transaction types that are presented to the customer. The available options are

°   None

°   Balance

°   Non-Cash Purchase

°   Transfer

°   Withdrawal

The default is None (all available options are presented to customer).

NOTE: If a specific transaction type is selected, it will only be presented to customer if the selected type has been disabled through the optional screens and buttons functions.

This function operates the same as Transaction Types. The available options are

°   Checking

°   Savings

°   Credit Card

The default is Checking.

Press 6 on the keypad repeatedly to cycle through the available account types.

This option determines if the terminal will go out of service when a low receipt paper condition occurs or stays in service.

This option determines if the terminal will go out of service when a printer error occurs or remains in service. If this option is unchecked, the terminal remains in service and the customer will be prompted that a receipt will NOT be printed. At that point they can accept or discontinue the transaction process.

This option, when enabled (checked), sends operational status information to the host processor. During certain transactions, one or all of the following are sent:

°   Transaction request message

°   Configuration table download request (working key download)

°   Host totals download request

°   Reversal request message

This option, when enabled (checked), instructs the terminal to initiate a Working Key download to the host processor. This allows the processor to determine if a particular terminal is still in operation.

NOTE: When this option is enabled, the Heartbeat Delay Period (next option) will be active to set the time period interval.

This option was added with the 3.1 version of software to the General Parameters menu to enable/disable the journal upload function. Previously, this feature could only be changed by the host processor.

NOTE: Check with your host processor before enabling this option!